BMW 3 Series E46

since 1998 release

Repair and operation of the car



BMW 3 Series E46
+ BMW 3 cars (E46)
+ Current leaving and service
+ Engine
+ Cooling systems, heating
+ Power supply systems, injection and release
+ Engine electric equipment
+ RKPP and transmission line
+ Automatic transmission
+ Coupling and power shafts
- Brake system
   Removal and installation of brake shoes of forward wheels
   Removal and installation of a guide of a forward brake
   Removal and installation of a brake disk of a forward wheel
   Removal and installation of brake shoes of disk brakes
   Removal and installation of a bracket of a brake of back wheels
   Removal and installation of a brake disk of a back wheel
   Measurement of thickness of a brake disk
   Brake fluid - the main data and security measures
   Removal of air from the brake system
   Replacement of the brake pipeline
   Replacement of a forward brake hose
   Check of the amplifier of a brake
   Removal and installation of blocks of the parking brake
   Adjustment of the parking brake
   Removal and installation of the lever of the parking brake
   Removal and installation of a cable of the drive of the parking brake
   Removal and installation of the switch of a stoplight
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment



Removal and installation of the switch of a stoplight

The switch of a stoplight is located around legs at a brake pedal support. It represents the contactless electronic switch and has practically no wear.

 REMOVAL

1 Turn off bolts of fastening and uncover in the left part of the region of an arrangement of legs, address to Removal and installation of facing forward parts of the region of legs.

2 I will corrode Rasstykuyte at the switch of a stoplight-1-, for this purpose squeeze clamps. 2 – brake loops. 3 – coupling switch.

3 Squeeze out a brake pedal. Pull a pusher-1-and a sleeve-2-completely forward-3-.

4 In this situation remove lock clips-4-and take out the switch from the holder back.


 INSTALLATION

1 Insert the switch with completely extended plug into a support of a pedal and record.
2 Displace the red lock plug towards the switch so that the fillet of the plug adjoined to a pedal support.
3 Join the socket and fix it.
4 Check whether the stoplight at the switched-off ignition and the pressed brake pedal lights up.
5 Establish into place a cover around an arrangement of legs, address the Section Removal and facing installation forward parts of the region of legs.