BMW 3 Series E46

since 1998 release

Repair and operation of the car



BMW 3 Series E46
+ BMW 3 cars (E46)
+ Current leaving and service
+ Engine
+ Cooling systems, heating
+ Power supply systems, injection and release
+ Engine electric equipment
+ RKPP and transmission line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   + Forward suspension bracket
   + Back suspension bracket
   - Steering with the hydraulic booster (servoupravleniye)
      Removal and installation of the block of a safety cushion on a steering wheel
      Removal and installation of a steering wheel
      Removal and installation of a tip of steering draft
      Removal and installation of steering draft
      Removal and installation of the pump of the hydraulic booster
      Filling with liquid and removal of air from a power steering hydraulic system
      Angles of installation of forward wheels. Check of installation of wheels
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment



Removal and installation of the pump of the hydraulic booster

Petrol engine

 REMOVAL

1 Suck away oil from the tank by means of the corresponding device or usual shliyets.
2 Remove the lower cover of a motive compartment, address the Section Removal and installation of the lower cover of a motive compartment.
3 Take off maple a belt, address the Section Removal, installation and a tension of a maple belt.

Hit in a hydraulic system of any pollution is not allowed. Close open pipelines and hoses traffic jams or polyethylene, having fixed it by a rubber plait.

4 Release a collar-1-and disconnect the soaking-up hose.

5 Turn off a cap nut and disconnect the pressure head line-2-.
6 Turn off bolts of fastening-3-and disconnect a pulley keeping him from rotation for an internal hexagon-4 shaft of the pump a face key on 10 mm.

7 Turn off from above two bolts of fastening-6 pumps of the hydraulic booster and remove the pump.-3 bolts of fastening of a pulley,-7 pulley.


 INSTALLATION

8 Insert into place the pump of the hydraulic booster and fix it by bolts.
9 Establish into place a pulley and fix it.
10 Fix the pressure head line by a cap nut.
The inhaling moments depending on diameter of a carving following:

M10 - 12 N • m
M14 - 35 N • m
M16 - 40 N • m
11 Put on maple a belt, address the Section Removal, installation and a tension of a maple belt.
12 Establish the lower cover of a motive compartment, address the Section Removal and installation of the lower cover of a motive compartment.
13 Fill system with new oil and remove air from system.

The liquid which was in the use repeatedly should not be applied.