BMW 3 Series E46
since 1998 release
Repair and operation of the car
BMW 3 Series E46
+ BMW 3 cars (E46)
+ Current leaving and service
+ Cooling systems, heating
- Power supply systems, injection and release
Security measures and rules of respect for purity during the work with fuel system
Removal and installation of the sensor of a reserve of fuel / fuel pump
Check of the sensor of a reserve of fuel
- Power supply system of petrol engines
Removal, installation and check of the relay of the fuel pump
Removal and installation of the fuel filter
Removal, installation and adjustment of the drive of a butterfly valve
Removal and installation of the air filter of the engine
+ System of injection of fuel of the petrol engine
+ Power supply system of diesel engines
+ System of production of the fulfilled gases
+ Engine electric equipment
+ RKPP and transmission line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Onboard electric equipment
+ Schemes of electric equipment
Детское кресло груша купить читать далее.
Power supply system of petrol engines
1 Lift and install the car horizontally on supports. Remove the lower cover of a motive compartment, address the Section Removal and installation of the lower cover of a motive compartment.
2 Install the selector in situation "P".
4 Wring out the lever of a box-3-forward in position of the parking. At the same time pull a cable-4-in an opposite direction and again release it.
5 Tighten a nut-2 moment of 10 N • m, holding at the same time the tightening plug-1-for a hexagon.
6 Check operation of the selector. For this purpose include ignition. At the motionless car the selector can move from situation "P" or "N" if the brake pedal is at the same time pressed.
7 The engine can be started only in position of the selector "P" and "N".
8 The ignition key can be taken out only in position of the selector "P".
9 Otherwise it is necessary to address on HUNDRED.