BMW 3 Series E46

since 1998 release

Repair and operation of the car


BMW 3 Series E46
+ BMW 3 cars (E46)
+ Current leaving and service
+ Engine
+ Cooling systems, heating
+ Power supply systems, injection and release
+ Engine electric equipment
+ RKPP and transmission line
- Automatic transmission
   Removal and AT installation
   Adjustment of draft of the selector
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment


Adjustment of draft of the selector

Rise and installation of the car on supports are dangerous! Therefore previously study Poddomkrachivaniye's Section and towage


 PERFORMANCE ORDER

1 Lift and install the car horizontally on supports. Remove the lower cover of a motive compartment, address the Section Removal and installation of the lower cover of a motive compartment.
2 Install the selector in situation "P".

3 Weaken a nut-2-on the lever of a box-3-, holding at the same time the tightening plug-1 a wrench from a provorachivaniye.

4 Wring out the lever of a box-3-forward in position of the parking. At the same time pull a cable-4-in an opposite direction and again release it.
5 Tighten a nut-2 moment of 10 N • m, holding at the same time the tightening plug-1-for a hexagon.
6 Check operation of the selector. For this purpose include ignition. At the motionless car the selector can move from situation "P" or "N" if the brake pedal is at the same time pressed.
7 The engine can be started only in position of the selector "P" and "N".
8 The ignition key can be taken out only in position of the selector "P".
9 Otherwise it is necessary to address on HUNDRED.