BMW 3 Series E46

since 1998 release

Repair and operation of the car


BMW 3 Series E46
+ BMW 3 cars (E46)
+ Current leaving and service
+ Engine
+ Cooling systems, heating
+ Power supply systems, injection and release
+ Engine electric equipment
+ RKPP and transmission line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   + Dignostic of electric elements
   - Lighting and alarm system
      Removal and installation/check of a sound signal
      Initialization of remote control
      Replacement of glow lamps of external lighting
      Replacement of glow lamps of internal lighting
      Removal and installation of a headlight
      Removal and installation of a ring cover of a headlight
      Removal and installation of the electric motor of adjustment of range of light
      Adjustment of headlights
      Gas-discharge lamps of passing beam (xenon lamps)
      Removal and installation of a back lamp
   + Devices and equipment
+ Schemes of electric equipment


Removal and installation of a headlight

 REMOVAL

1 Remove if is available, the nozzle of a faroomyvatel located under a headlight, address the Section Removal, installation and check of nozzles of a faroomyvatel.
2 Open a cowl.

3 Release an internal peak-1-and squeeze out it from holders-2-down.

4 Remove a peak on outer side-3-forward. For this purpose it is necessary to pull with a force for a peak.
5 Rasstykuyte all shtekerny connections from a reverse side of a headlight.

6 Mark the provision of a headlight for what lead round a felt-tip pen of a washer of screws of fastening (shooters on an illustration). Thanks to it at installation the headlight can be put in former position. Unscrew screws of fastening of a headlight and remove it forward.


 INSTALLATION

7 Insert a headlight and tighten fastening screws by hand.
8 Expose a headlight so that washers of screws of fastening reached the position marked at removal.
9 If the new headlight is established, pull it completely forward. Close a cowl and expose a headlight so that it coincided with a body contour. Open a cowl and tighten screws of fastening of a headlight.
10 Join the socket of lamps.
11 Establish a peak outside under a headlight, incline inside and record.
12 Fix a nozzle of a faroomyvatel if it is available, address the Section Removal, installation and check of nozzles of a faroomyvatel.

In conclusion adjust a headlight on HUNDRED.