Removal, installation and check of nozzles of a faroomyvatel
REMOVAL
1 Take out a nozzle-1-by means of a plastic wedge-2-of the shutter of a headlight and extend it against the stop.
At removal of a nozzle water therefore cover a nozzle with a rag follows and substitute the corresponding capacity. If necessary insert the corresponding stopper into a tube.
2 Remove breakthrough a nozzle from a tube. The tube itself departs after that back.
INSTALLATION
The left and right nozzles differ from each other. Not to mix them, they have on the lower part marking of "R" and "L". If the nozzle is replaced, disconnect the shutter and rearrange it on a new nozzle.
3 Insert a nozzle into an opening in the shutter of a headlight and enter into a tube. 4 Take out a nozzle check whether the tube on accession is fixed. If necessary put on it and record. 5 Insert a nozzle into the headlight shutter.
CHECK
6 Include ignition, turn on the light and ask the assistant to turn on the windscreen washer switch. 7 The stream of water has to get to the center of a headlight of near and far light.
If the faroomyvatel has to join again, it is previously necessary to switch on and off ignition as differently the washer is blocked for 3 min.