BMW 3 Series E46

since 1998 release

Repair and operation of the car



BMW 3 Series E46
+ BMW 3 cars (E46)
+ Current leaving and service
+ Engine
+ Cooling systems, heating
+ Power supply systems, injection and release
+ Engine electric equipment
+ RKPP and transmission line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
- Body
   General information and security measures
   + Leaving and repair of damages of a body
   - External elements of a body
      Removal and installation of a front bumper
      Removal and installation/check of shock-absorbers of a bumper
      Removal and installation of a rear bumper
      Removal and installation of the back shock-absorber
      Removal and installation of a cover of a fairing
      Removal and installation of a forward wing
      Removal and installation of a cowl
      Adjustment of a cowl
      Removal and installation of a trunk lid
      Adjustment of a trunk lid
      Removal and installation of the lock/cylinder of the lock of a trunk lid
      Removal and installation of a gas-filled emphasis of a cowl/trunk lid
      Replacement of moldings and emblem of model
      Removal, installation and adjustment of a door
      Removal and installation of facing of a door
      Removal and installation of the lock of a door
      Removal and installation of the cylinder of the lock
      Removal and installation of the external handle of a door
      Removal, installation and adjustment of a window
      Removal and installation of the power window
      Removal and installation of the electric motor of a window regulator
      Removal and installation of a mirror of an external look / sound signal of high-pitch tone
      Removal and installation of glass of a mirror
      Removal and installation of the case of a mirror of an exterior
   + Internal elements of a body
+ Onboard electric equipment
+ Schemes of electric equipment





Removal and installation of the power window

 REMOVAL

1 Remove facing of a door and a cover of a door in a back part, address appropriate section.
2 Unscrew screws of fastening of glass to a window regulator, displace glass completely up and fix by two wedges from within.
3 Turn off nuts-2-and-3 fastenings of the back tire of a window regulator-1-. Previously remove sealant from a nut-3-.
4 Take out the tire back a window regulator inside down and put in doors.

5 Cut off a cable-1-collar.

6 Take out a clip-2-.
7 Rasstykuyte socket-3-.
8 Turn off nuts-4-and-5-.
9 Take out the forward tire of a window regulator-6-with the electric motor-7-inside down and put below in doors.
10 Take out a window regulator from a door. At the same time at first take out a forward part through an opening in a leaf of a door.


 INSTALLATION

11 Insert a window regulator into a door and displace a finger through an opening in a leaf of a door.
12 Fix a window regulator by the moment of 8 N • m. Behind on the lower nut put sealant.
13 Join the socket at the electric motor.
14 Fix a clip for the door directing a cable on a leaf.
15 Fix the top guide with a new collar of a cable on a leaf of a door.
16 Fix glass by screws and adjust, address appropriate section.
17 Establish facing of a door, address appropriate section.